From
5.700 kg
Unladen weight
To
32,5 m³
Load volume
Original
Hardox®
Steel
> 50°
Tilt angle
Half-Pipe tipper Steel (SKS-HS)
The new half-shell body
with 4 mm floor and side walls made of Hardox® steel
Standard:
HARDOX® HB 450
Steps in the trough
Four-point bearing of the tilting press
Combination press for high and low pressure
Operating stand on the chassis
Optional:
Different bottom and side wall thicknesses
Hydraulic rear panel designed as a combination flap, with single and double-acting cylinder
Wabco OptiTire
Wabco Safe-Start
Mounting loading camera
Observation stand on the bulkhead with electr. convertible top
Pneumatic underride guard
Available with and without chute
High quality implementation
- down to the smallest detail
The new design qualifies the Langendorf half-shell body for an even wider range of applications. The base and side walls of the skip are made of 4 mm high-strength Hardox® HB 450 fine-grained steel. Due to the thinner walls, a lower dead weight can be achieved and the skip can take heavier loads. In order to still maintain the durability and quality of the body at the high standard typical of Langendorf, the side walls have been equipped with an additional bend that does not allow any compromise in quality.
